1、人員正常速度從門外或門內走向感應門，感應自動門應該自動打開，感應自動門的動作應該平滑而且沒有出現碰撞的情況；濟南感應門打開后，人員以正常速度通過感應門時，感應自動門應該保持打開狀態。

1. Personnel should move towards the sensing door from outside or inside the door at normal speed. The sensing automatic door should automatically open, and the movement of the sensing automatic door should be smooth and there should be no collision; After the Jinan sensing door is opened, when personnel pass through the sensing door at normal speed, the sensing automatic door should remain open.

2、當人員離開感應自動門感應器感應區后，在延時1-10秒后（時間長短可以由感應自動門開關參數來設置），感應自動門將自動關閉，感應自動門的動作應該平滑而且沒有出現碰撞的情況。

2. When a person leaves the sensing area of the induction automatic door sensor, after a delay of 1-10 seconds (the duration can be set by the parameters of the induction automatic door switch), the induction automatic door will automatically close, and the action of the induction automatic door should be smooth and there should be no collision.

3、觀察正常通過感應自動門的行走路線，需要把日常行走路線調整為人員正對走向感應自動門，而不是以一定的角度走向感應自動門。

3. To observe the normal walking route through the induction automatic door, it is necessary to adjust the daily walking route to the person facing towards the induction automatic door, rather than walking towards the induction automatic door at a certain angle.

4、走向感應自動門時，感應自動門感應器的感應寬度范圍應該大于門完全打開的寬度。

4. When walking towards the sensing automatic door, the sensing width range of the sensing automatic door sensor should be greater than the width of the fully opened door.

5、***的自動平移門的控制器，都設有自動反向功能的程序：不管開啟或關閉過程中，當門體運動方向上遇到障礙物或人時，門體會自動向相反方向運動。這是一個非常重要的、保護功能，在防止碰人或物的同時，保護感應自動門機不會因過載而燒壞。然后，門體在退回時自動執行學習程序時，不能有任何信號干擾，否則，微處理器將繼續執行學習程序。如果長時間未能恢復正常，就會出現故障或功能異常。

5. The controllers of high-end automatic sliding doors are equipped with automatic reverse function programs: whether opening or closing, when the door encounters obstacles or people in the direction of movement, the door will automatically move in the opposite direction. This is a very important safety and protection function, which not only prevents touching people or objects, but also protects the induction automatic door machine from burning out due to overload. Then, when the gate body automatically executes the learning program when returning, there must be no signal interference, otherwise, the microprocessor will continue to execute the learning program. If normal operation is not restored for a long time, malfunctions or functional abnormalities may occur.

6、在通過人員的數量有限的環境中，自動反射功能可以作為性功能來防止碰人和夾人，但在大人員流量的公共區域，性功能應該特殊考慮。

6. In environments with a limited number of personnel, the automatic reflection function can serve as a safety function to prevent contact and entrapment, but in public areas with high traffic, safety functions should be given special consideration.

7、出現異常聲音和故障時，勿隨意拆裝，請及時關閉電源并與技術員聯系。

7. When abnormal sounds or malfunctions occur, do not disassemble or disassemble at will. Please turn off the power in a timely manner and contact the technician.

8、感應自動門軌道及吊輪不能上油；否則吊架上的滾輪有滑動現象，使門發生碰撞。

8. The induction automatic door track and lifting wheel cannot be oiled; Otherwise, the rollers on the hanger may slide, causing the door to collide.

通行人員了解感應自動門使用常識與感應自動門使用事項，保障在通行感應自動門時、迅速。更多相關事項就來我們網站http://www.hzsxbj.com咨詢！

Passengers should understand the common sense of using induction automatic doors and the safety precautions for using induction automatic doors to ensure safety and speed when passing through them. For more related matters, come to our website http://www.hzsxbj.com consulting service